| Machining
Parameters |
| Turning |
|
|
| Cutting
speed, m/min |
90 |
240 |
| Feed,
mm/rev |
0,1 |
0,6 |
| Relief
Angle, ° |
5 |
15 |
| Rake
Angle, ° |
7 |
15 |
| Cutting
depth, mm |
0,6 |
|
| Circular sawing |
|
|
| Cutting
speed, m/min |
1830 |
2440 |
| Feed,
mm/rev |
fast
& steady |
| Relief
Angle, ° |
15 |
|
| Set |
slight |
| Rake
Angle, ° |
15 |
|
| Milling |
|
|
| Cutting
speed, m/min |
150 |
240 |
| Feed,
mm/rev |
0,15 |
0,9 |
| Relief
Angle, ° |
5 |
15 |
| Rake
Angle, ° |
7 |
15 |
| Cutting
depth, mm |
0,9 |
|
| Drilling |
|
|
| Cutting
speed, m/min |
90 |
240 |
| Feed,
mm/rev |
0,1 |
0,4 |
| Relief
Angle, ° |
0 |
|
| Point
angle, ° |
118 |
|
| Reaming |
|
|
| Slow
speed, rpm |
150 |
|
|
Machined Parts Should be Recured.
Parts designed for friction and wear-intensive
service, or which will be subjected to harsh chemical environments,
should be recured after machining to insure optimum performance. If
such a part has been machined to greater than 1.6 mm depth,
recuring is strongly recommended. (from the Solvay Torlon Design Manual)
|
|
